# ----   Example of a MOS file for DOlORES/TNG -----
#
#
# Each line describes the slit position by means of 3 numbers as follows.
#
#  Xc : the position of the slit center (valid range -180 to +180)
#  Y1 : the position of the lower slit edge (valid range -230 to +230)
#  Y2 : the position of the upper slit edge (valid range -230 to +230)
#
# All the positions are in arcsec and measured from the center of the 
# mask. Lines containing out-of-range values or Y1>Y2 will be ignored.
#
# This file can also contain comment lines like these ones or comments
# appended after the third number entry of any line
#
# 
#       Xc           Y1          Y2 
#
      -1.214        -184.3    -184.3   # pivot object n.1
      -108.4       157.3       157.3   # pivot object n.2
#
# Please include the pivot objects at the beginning of your file
#
       57.91      -145.8      -134.2
       77.97       211.7       228.3
        -137      -204.6      -192.6
      -106.7       2.667       14.67
      -83.81      -28.02      -16.02
       -67.1      -110.3       -98.3
      -5.352       191.2       205.2
       21.41      -49.19      -37.19
       34.21      -177.3      -165.3
       48.58      -63.97      -51.97
       51.76       114.7       126.7
        80.2      -92.65      -80.65
       88.81      -130.9      -118.9
       92.85       99.12       111.1
         158       31.73       50.73
       83.98      -220.3      -208.3
       12.81         173         187
       25.47       131.9       145.9
       84.45       76.89       90.89
      -75.0       -162        -150